22.2.1 Command list
The following tables list CFM configuration commands.
Command name |
Description |
---|---|
domain name |
Sets the name used for the applicable domain. |
ethernet cfm cc alarm-priority |
Sets the failure level detected by the CC functionality. |
ethernet cfm cc alarm-reset-time |
Sets the period of time until the CC functionality recognizes that the failure is a redetected failure. |
ethernet cfm cc alarm-start-time |
Set the number of seconds between when a failure is detected by CC and when SNMP notification is sent. |
ethernet cfm cc enable |
Sets in a domain an MA in which the CC functionality is used. |
ethernet cfm cc interval |
Sets the CCM sending interval. |
ethernet cfm domain |
Sets a domain. |
ethernet cfm enable (global) |
Starts CFM. |
ethernet cfm enable (interface) |
Stops CFM when no ethernet cfm enable is set. |
ethernet cfm mep |
Sets a MEP used by the CFM functionality. |
ethernet cfm mip |
Sets a MIP used by the CFM functionality. |
ma name |
Sets the name of an MA to be used in the applicable domain. |
ma vlan-group |
Sets the VLAN belonging to the MA used in the applicable domain. |
The following tables list the operation commands for CFM.
Command name |
Description |
---|---|
l2ping |
Executes the CFM loopback functionality and verifies the connectivity between the specified MPs. |
l2traceroute |
Executes the CFM linktrace functionality and verifies the routing between the specified MPs. |
show cfm |
Shows information about a CFM domain. |
show cfm remote-mep |
Shows information about a CFM remote MEP. |
show cfm fault |
Shows CFM failure information. |
show cfm l2traceroute-db |
Shows routing information obtained by using the l2traceroute command. |
show cfm statistics |
Shows CFM statistics. |
clear cfm remote-mep |
Clears remote information about a CFM MEP. |
clear cfm fault |
Clears CFM failure information. |
clear cfm l2traceroute-db |
Clears route information obtained by using the l2traceroute command. |
clear cfm statistics |
Clears CFM statistics. |
restart cfm |
Restarts the CFM program. |
dump protocols cfm |
Outputs CFM dump information to a file. |