15.1.2 Support Specifications
The following table describes the specifications supported for uplink redundancy.
|
Item |
Support or specified value |
|
|---|---|---|
|
Applicable interfaces |
Physical ports |
OK |
|
Link Aggregation |
OK |
|
|
Number of uplink ports |
See "Configuration Guide Vol.1" "3 Capacity Limits". |
|
|
Number of interfaces that can be configured for one uplink port pair |
2 |
|
|
Automatic active-port switch-back to the primary port |
OK |
|
|
Suppression of automatic active-port switch-back to the primary port |
OK |
|
|
Command for changing the active port |
OK |
|
|
Flash Control Frame Transmission/Reception Function at Active Port Change |
OK |
|
|
MAC Address Update Function When Changing the Active Port |
OK |
|
|
Port Reset Function When Changing the Active Port |
OK |
|
|
Fixed Active Port Function at Startup |
OK # |
|
|
Private MIB, private SNMP notification |
OK |
|
Legend: OK: Supported
- #
-
This function is released when the master switch is switched during stack configuration.