7.1.1 Command list
The following tables list IEEE802.1X configuration commands.
Command name |
Description |
---|---|
aaa accounting dot1x default |
Enables the collection of accounting information by the RADIUS server. |
aaa authentication dot1x default |
Configures the switch to use the RADIUS server for IEEE 802.1X user authentication. |
dot1x ignore-eapol-start |
Configures the switch not to transmit EAP-Request/Identity packets in response to an EAPOL-Start message received from a supplicant. |
dot1x logging enable |
Sends IEEE802.1X operation log messages to syslog servers or email addresses (using E-Mail). |
dot1x loglevel |
Specifies the message level to write to the operation log. |
dot1x max-req |
Specifies the maximum number of times that the switch sends an EAP-Request/Identity packet when there is no response from the supplicant. |
dot1x max-supplicant |
Specifies the maximum number of authenticated users permitted per authentication unit. |
dot1x multiple-hosts dot1x multiple-authentication |
Sets IEEE802.1X authentication submode. |
dot1x port-control |
Enables IEEE802.1X authorization for the specified interfaces. |
dot1x radius-server host |
Specify IP of RADIUS servers for IEEE802.1X only. |
dot1x reauthentication |
Enables or disables periodic re-authentication of authenticated terminals. |
dot1x supplicant-detection |
Configures how terminal detection is performed when terminal authentication mode is specified as the authentication sub-mode. |
dot1x system-auth-control |
Enables IEEE 802.1X. |
dot1x timeout keep-unauth |
Sets the time to retain the communication shutdown status on an interface when an authentication request from multiple terminals is detected in single mode of the authentication submode. |
dot1x timeout quiet-period |
Configures how long the switch waits before allowing a supplicant that failed authentication (including re-authentication) to try again. |
dot1x timeout reauth-period |
Specifies the interval between re-authentication attempts for authenticated terminals. |
dot1x timeout server-timeout |
Specifies how long the switch waits for a response from the authentication server. |
dot1x timeout supp-timeout |
Configures how long the switch waits for a supplicant to respond to an EAP-Request/Identity packet. |
dot1x timeout tx-period |
Specifies the sending interval for EAP-Request/Identity packets. |
The following lists the operation commands that check IEEE802.1X status.
Command name |
Description |
---|---|
show dot1x |
Shows the status of each authentication unit and information about authenticated supplicants. |
show dot1x logging |
Shows the operation log messages output by the IEEE 802.1X software. |
show dot1x statistics |
Shows statistics about IEEE 802.1X authentication. |
clear dot1x auth-state |
Clears information related to authenticated terminals. |
clear dot1x logging |
Clears the operation log messages output by the IEEE 802.1X software. |
clear dot1x statistics |
Resets IEEE 802.1X-related statistics to 0. |
reauthenticate dot1x |
Re-authenticates the status of IEEE 802.1X authentication. |
restart dot1x |
Restarts the IEEE 802.1X program. |
dump protocols dot1x |
Outputs the control table information and statistics gathered by the IEEE 802.1X software to a file. |