4.4.1 Setting the queuing priority
Set the queuing priority for certain types of flows.
- Points to note
-
When frames are received, first flow detection is performed based on the destination IP address, and then the queuing priority is set.
Command examples
-
(config)# ip qos-flow-list QOS-LIST2
Creates a IPv4 QoS flow list (QOS-LIST2). By creating this list, IPv4 QoS flow list mode is entered.
-
(config-ip-qos)# qos ip any host 192.168.100.10 action discard-class 2
Sets the IPv4 QoS flow list for destination IP address 192.168.100.10, and then sets the queuing priority to 2.
-
(config-ip-qos)# exit
Returns to global configuration mode from IPv4 QoS flow list mode.
-
(config)# interface gigabitethernet 1/0/1
Moves to port 1/0/1 interface mode.
-
(config-if)# ip qos-flow-group QOS-LIST2 in
Enables the QoS flow list (QOS-LIST2) on the receiving side.