3.2.2 Specifying QoS Control for Multiple Interfaces
The following shows an example of specifying QoS control on multiple Ethernet interfaces.
- Points to note
-
By enabling QoS control in config-if-range mode, you can set QoS control for multiple Ethernet interfaces.
Command examples
-
(config)# ip qos-flow-list QOS-LIST1
Creates an IPv4 QoS flow list (QOS-LIST1), and then switches to IPv4 QoS flow list mode. By creating this list, IPv4 QoS flow list mode is entered.
-
(config-ip-qos)# qos ip any host 192.168.100.10 action cos 6
Configures the QoS flow list for destination IP address 192.168.100.10, and then sets a CoS value of 6.
-
(config-ip-qos)# exit
Returns to global configuration mode from IPv4 QoS flow list mode.
-
(config)# interface range gigabitethernet 1/0/1-4
Switches to the interface mode for ports 1/0/1-4.
-
(config-if-range)# ip qos-flow-group QOS-LIST1 in
Enables the IPv4 QoS flow list on the receiving side.