35.2.1 Command list
The following tables list the commands used to configure IPv6 communication.
|
Command name |
Description |
|---|---|
|
ipv6 address |
Sets the IPv6 address. |
|
ipv6 enable |
Enables IPv6 on an interface. This command automatically creates a link-local address. |
|
ipv6 icmp error-interval |
Specifies the sending interval of ICMPv6 error messages. |
|
ipv6 nd accept-ra |
Receives Router Advertisement messages and performs stateless address auto-generation. |
|
ipv6 neighbor |
Creates a static NDP table. |
|
ipv6 route |
Generates an IPv6 static route. |
|
interface loopback # |
Moves to the loopback interface level. |
|
ipv6 address (loopback) # |
Specifies an IPv6 address for a loopback interface. |
- #
-
See Configuration Command Reference, 25 Loopback Interface.
The following tables list the operation commands for IPv6 communication.
|
Command name |
Description |
|---|---|
|
show ip-dual interface |
Shows the status of IPv4 and IPv6 interfaces. |
|
show ipv6 interface |
Shows the status of the IPv6 interface. |
|
show ipv6 neighbors |
Shows NDP information. |
|
clear ipv6 neighbors |
Clears dynamic NDP information. |
|
show netstat (netstat) |
Shows the status of a network. |
|
ping ipv6 |
Performs an ICMPv6 Echo test. |
|
traceroute ipv6 |
Shows an IPv6 route. |
|
show ipv6 route |
Displays the routing table for IPv6. |
|
show ipv6 router-advertisement |
Displays the address and default route information for receiving Router Advertisement messages. |
|
show tcpdump |
Monitors incoming and outgoing packets. |