26.2.1 Command list
The following tables list the commands used to configure the basic VLAN functionality.
|
Command name |
Description |
|---|---|
|
name |
Sets a VLAN name. |
|
state |
Sets VLAN status (stop/start). |
|
switchport access |
Sets the access port VLAN. |
|
switchport dot1q ethertype |
Sets the VLAN tag TPID for port. |
|
switchport mode |
Sets the port type (access, protocol, MAC, trunk, or tunneling). |
|
switchport trunk |
Sets the VLAN for a trunk port. |
|
vlan |
The example below shows how to create a VLAN. Also, sets items pertaining to a VLAN in VLAN configuration mode. |
|
vlan-dot1q-ethertype |
Sets the default value for VLAN tag TPIDs. |
|
vlan-up-message |
Use no vlan-up-message command to suppress the sending of operation messages and LinkUp/LinkDown traps during Up and Down of VLAN. |
The following tables list the operation commands for VLAN.
|
Command name |
Description |
|---|---|
|
show vlan |
Shows information about VLANs. |
|
show vlan mac-vlan |
Shows the MAC addresses registered for MAC VLANs. |
|
restart vlan |
Restarts the VLAN program. |
|
dump protocols vlan |
Outputs to a file detailed event trace information and control tables collected for a VLAN program. |