23.2.1 Command list

The following table lists the commands used to configure the basic link aggregation functionality.

Table 23-1: List of configuration commands
Command name	Description
channel-group lacp system-priority	Sets the LACP system priority for each channel group.
channel-group mode	Adds a port to a channel group.
channel-group periodic-timer	Sets the LACPDU sending interval.
description	Sets supplementary information about a channel group.
interface port-channel	Sets up a port channel interface. The parameters of a channel group are also set in port channel interface configuration mode.
lacp port-priority	Sets the LACP port priority.
lacp system-priority	Sets the default for the LACP system priority.
shutdown	Stops communication for a channel group

The following table describes the operation commands for link aggregation.

Table 23-2: List of operation commands
Command name	Description
show channel-group	Shows link aggregation information.
show channel-group statistics	Shows link aggregation statistics.
clear channel-group statistics lacp	Clears the statistics for sent and received LACPDUs.
restart link-aggregation	Restarts the link aggregation program.
dump protocols link-aggregation	Exports the detailed event trace information and control table information for link aggregation to a file.