22.4.1 Command list

The following table lists the commands used to configure Ethernet.

Table 22-16: List of configuration commands
Command name	Description
bandwidth	Sets the bandwidth.
description	Sets supplementary information.
duplex	Sets duplex mode.
flowcontrol	Sets flow control.
frame-error-notice	Sets the condition for sending a notification when a frame reception error or a frame sending error occurs.
interface gigabitethernet	Specifies an Ethernet internet configuration with a maximum line speed of 1000 Mbit/s.
interface tengigabitethernet	Specifies the configuration of the Ethernet interface with the highest line speed 10Gbit/s.
link debounce	Sets the time required before a link-down is detected.
link up-debounce	Sets the time required before a link-up is detected.
mdix auto	Set the auto MDI/MDIX function.
mtu	Sets the Ethernet MTU.
power inline	Set the power supply priority for each port.
power inline allocation	Sets the per-port power allocation.
power inline delay	Set PoE power supply start wait time of the device and the power supply start interval of PoE port.
power inline priority-control disable	The port that is already powered is given priority.
shutdown	Shuts down Ethernet.
speed	Sets the speed.
system flowcontrol off	The example below shows how to disable flow control for all ports on the switch.
system mtu	Sets a value for an Ethernet MTU device.

The following table lists the operation commands related to Ethernet.

Table 22-17: List of operation commands
Command name	Description
show interfaces	Displays Ethernet information.
clear counters	Clears the Ethernet statistics counters.
show port	Displays Ethernet information in list format.
activate	Changes the status of an Ethernet port from inactive to active.
inactivate	Changes the status of an Ethernet port from active to inactive.
test interfaces	Conducts a line test.
no test interfaces	Stops a line test, and displays the test results.
show power inline	Displays device and per-port PoE.
activate power inline	Restart the power supply manually.
inactivate power inline	Stops the power supply manually.