9.2.1 Command list

The following table lists the commands used to configure the connection and remote operation of operation terminals.

Table 9-1: List of configuration commands
Command name	Description
ftp-server	Permits access from remote operation terminals using FTP.
line console	Sets parameters for the RS232C port.
line vty	Allows remote access to the appliance.
speed	Sets the communication speed of the RS232C port.
transport input	Regulates access from a remote operation terminal using the various protocols.

The following table lists the operation commands related to connection and remote operation of operation terminals.

Table 9-2: List of operation commands
Command name	Description
set exec-timeout	Specifies the length of time until the user is automatically logged out.
set terminal help	Selects the type of command help messages to be displayed.
set terminal pager	Enables or disables paging.
show history	Shows a log of operation commands executed in the past. (No log is displayed for configuration commands.)
telnet	Connects via Telnet to the remote operation terminal that has the specified IP address.
ftp	Transfers files between the Switch and a remote terminal connected by using TCP/IP.
tftp	Transfers files between the Switch and a remote terminal connected by using UDP.

For information about configuring SSH, see 11 SSH(Secure Shell).

For configuration commands related to VLAN settings and IP interface settings, see "26 VLAN", "34 IPv4 communication", or "35 IPv6 communication".