8.1.1 Command list
The following table lists the commands used to configure stacks.
|
Command name |
Description |
|---|---|
|
stack enable |
Enables the stacking feature. |
|
switch priority |
Sets the master election priority. |
|
switch provision #1 |
Sets the model of the member switches that make up the stack. |
|
switchport mode #2 |
Sets the port to connect between the member switches that make up the stack. |
- #1
-
See Configuration Command Reference, 9 Managing the Switch.
- #2
-
See "Configuration Command Reference" "18 VLAN".
The following table lists the operation commands related to stacks.
|
Command name |
Description |
|---|---|
|
show switch |
Displays information about the member switches that make up the stack. |
|
remote command |
Executes the operation command for the specified member switch from the master switch. |
|
set switch |
Sets the switch number of the member switch. |
|
dump stack |
Outputs to a file detailed event trace information and control table information collected by the stack management program. |
|
session |
Connect to the other member switches that make up the stack. |