3.12.2 CFM
The following table describes the capacity limits for CFM.
Model |
Number of domains |
Number of MAs |
Number of MEPs |
Number of MIPs |
Total number of CFM ports*1*2 |
Total number of remote MEP *2 *3 |
---|---|---|---|---|---|---|
All models |
8/Device |
32/device |
32/device |
32/device |
256/device |
2016/device |
- #1
-
Total number of CFM ports is the total number of VLAN ports that send CFM frames in the primary VLAN associated with the MA.
- When the MA contains only Down MEPs:
-
Total number of VLAN ports in Down MEP
- When the MA contains both Down and Up MEPs:
-
Total number of VLAN ports on the primary VLAN
You can check the total number of CFM ports using the show cfm summary operation command.
- #2
-
The total number of CFM ports and total number of remote MEPs are governed by the capacity limits when using the default CCM sending interval. The capacity limits of the total number of CFM ports and total number of remote MEPs change if you change the CCM sending interval. The following table describes the capacity limits for total CFM ports and total remote MEPs according to the set CCM sending interval.
Table 3-45 Accommodation conditions according to CCM transmission interval Model
Interval for sending CCMs
Total number of CFM ports
Total number of remote MEPs
All models
1 minute or longer
256/device
2016/device
10 seconds
128/device
2016/device
1 second
50/equipment
200/device
- #3
-
Total number of remote MEPs is the sum of MEPs on other devices. This affects the CCM receiving performance from MEPs. You can check the total number of remote MEPs using the show cfm remote-mep operation command.
Model |
Total number of physical ports and channel groups for which MEP .MIP can be set# |
---|---|
All models |
8/Device |
- #
-
Multiple MEPs or MIPs can be assigned to the same port. Each channel group is counted as one port.
Model |
MEP CCM Database Number of entries |
MIP CCM Database Number of entries |
Linktrace Database Number of entries# |
---|---|---|---|
All models |
63/MEP |
2048/device |
1024/switch |
- #
-
If information for 256 devices is stored per route, the database can store information for a maximum of four routes (1024 / 256 devices = 4 routes).