2.11.3 2017XXXX (Ring Protocol)

This section describes operation messages in which the upper four digits of the message identifier are 2017.

Table 2-20: Operation messages for event location VLAN (2017XXXX)
Message ID	Event Level	Message text
Message ID	Content and response
20170003	E3	AXRP <ring id> : cleared MAC address table by receiving flush request frames.
20170003	A flush control frame was received, and the MAC address table was cleared. <ring id>: Ring ID [Action] None.
20170005	E3	AXRP <ring id> : cleared MAC address table by timeout of forwarding-shift-timer.
20170005	A MAC address table was cleared due to a forwarding-shift-time timeout. The switch outputs this message when a forwarding-shift-time timeout is detected and the MAC address table is output. <ring id>: Ring ID [Action] None.
20170014	E3	AXRP(virtual-link <link id>) : cleared MAC address table by receiving flush frames.
20170014	A virtual link flush control frame was received with Ring Protocol, and MAC address table entries were cleared. This message is for the clearing of MAC address table entries for learning at all ring ports. <link id>: Virtual link ID [Action] None.
20170021	E3	AXRP (multi-fault-detection <ring id>) : cleared MAC address table by receiving flush frames.
20170021	A multi-fault flush control frame was received, and the MAC address table was cleared. A flush control frame for multiple failures is a flush control frame in which only MAC address table transmitted by the shared node is cleared when the multiple failure monitoring function is enabled. <ring id>: Ring ID [Action] None.
20170024	E4	AXRP : logical inconsistency occurred.
20170024	An internal-status conflict occurred in Ring Protocol. [Action] Execute restart axrp command. Then restart Ring Protocol program.