2.5 CONFIG
This section describes the operation messages for the event location CONFIG.
Message ID |
Event Level |
Message text |
---|---|---|
Content and response |
||
09300001 |
E3 |
This system started with the default configuration file. because the startup configuration file is not found or broken. |
Operation started with the default configuration information for one of the following reasons:
[Action]
|
||
09300002 |
E3 |
Configuration command syntax error. line <line number> : "<error syntax>" |
Application to the running configuration was skipped because a syntax error was detected in the startup configuration file. <line number>: Line number of the target configuration command <error syntax>: Syntax of the target configuration command [Action] Check the contents of the error. |
||
09300008 |
E3 |
Cannot set the automatic setting configuration command.:<command> |
Automatic setting of the configuration command failed. <command>: Command name [Action] Manually set the corresponding command. |
||
09600006 |
E3 |
Configuration access management error. process<process name>:pid<process id>:time <time> |
The lock was released and the device was automatically recovered because a process was accessing the configuration for a long time. <process name>: Occurrence process name <process id>: Occurrence process ID <time>: Occurrence time (day-of-the-week month day hour:minutes:seconds year) [Action] None. |