21.2.1 Command list

domain name

Sets the name used for the applicable domain.

ethernet cfm cc alarm-priority

Sets the failure level detected by the CC functionality.

ethernet cfm cc alarm-reset-time

Sets the period of time until the CC functionality recognizes that the failure is a redetected failure.

ethernet cfm cc alarm-start-time

Set the number of seconds between when a failure is detected by CC and when SNMP notification is sent.

ethernet cfm cc enable

Sets in a domain an MA in which the CC functionality is used.

ethernet cfm cc interval

Sets the CCM sending interval.

ethernet cfm domain

Sets a domain.

ethernet cfm enable (global)

Starts CFM.

ethernet cfm enable (interface)

Stops CFM when no ethernet cfm enable is set.

ethernet cfm mep

Sets a MEP used by the CFM functionality.

ethernet cfm mip

Sets a MIP used by the CFM functionality.

ma name

Sets the name of an MA to be used in the applicable domain.

ma vlan-group

Sets the VLAN belonging to the MA used in the applicable domain.

l2ping

Executes the CFM loopback functionality and verifies the connectivity between the specified MPs.

l2traceroute

Executes the CFM linktrace functionality and verifies the routing between the specified MPs.

show cfm

Shows information about a CFM domain.

show cfm remote-mep

Shows information about a CFM remote MEP.

show cfm fault

Shows CFM failure information.

show cfm l2traceroute-db

Shows routing information obtained by using the l2traceroute command.

show cfm statistics

Shows CFM statistics.

clear cfm remote-mep

Clears remote information about a CFM MEP.

clear cfm fault

Clears CFM failure information.

clear cfm l2traceroute-db

Clears route information obtained by using the l2traceroute command.

clear cfm statistics

Clears CFM statistics.

restart cfm

Restarts the CFM program.

dump protocols cfm

Outputs CFM dump information to a file.