7.1.3 Setting Fixed VLAN Mode
Sets the authentication mode to fixed VLAN mode for a given interface.
- Points to note
-
Configure an access port and enable IEEE 802.1X authentication on that port. You then specify the authentication sub-mode. If you omit the authentication sub-mode setting, the port will operate in single-terminal mode.
Command examples
-
(config)# interface gigabitethernet 1/0/1
(config-if)# switchport mode access
Places port 1/0/1 in access mode.
-
(config-if)# dot1x multiple-authentication
Specifies terminal authentication mode as the authentication sub-mode.
-
(config-if)# dot1x port-control auto
Enable IEEE 802.1X authentication.