3.4.1 User priority rewrite setting
The following describes the configuration when the user priority is to be updated for certain types of flows.
- Points to note
-
When frames are received, first flow detection is performed based on the destination IP address, and then the user priority is updated.
Command examples
-
(config)# ip qos-flow-list QOS-LIST1
Creates an IPv4 QoS flow list (QOS-LIST1), and then switches to IPv4 QoS flow list mode. By creating this list, IPv4 QoS flow list mode is entered.
-
(config-ip-qos)# qos ip any host 192.168.100.10 action replace-user-priority 6
Configures the IPv4 QoS flow list for destination IP address 192.168.100.10, and then changes the current user priority to 6.
-
(config-ip-qos)# exit
Returns to global configuration mode from IPv4 QoS flow list mode.
-
(config)# interface gigabitethernet 1/0/1
Moves to port 1/0/1 interface mode.
-
(config-if)# ip qos-flow-group QOS-LIST1 in
Enables the IPv4 QoS flow list (QOS-LIST1) on the receiving side.