32.2.3 Manually Configuring Link-Local Addresses
- Points to note
-
The Switch automatically generates a link-local address when you execute the ipv6 enable configuration command. Each interface can have one link-local address, which, if you prefer, can be set manually.
Command examples
-
(config)# interface vlan 100
Switches to interface configuration mode for VLAN ID 100.
-
(config-if)# ipv6 enable
Enables the use of an IPv6 address for VLAN ID 100. At this time, a link-local address is automatically generated.
-
(config-if)# ipv6 address fe80::1 link-local
Changes the link-local address automatically set for VLAN ID 100 to fe80::1.