28.1.1 Command list
The following tables list Ring Protocol configuration commands.
Command name |
Description |
---|---|
axrp |
Set a ring ID. |
axrp vlan-mapping |
Sets the VLAN mapping and VLANs participating in the mapping. |
axrp-ring-port |
Sets the ring port. |
control-vlan |
Sets the VLAN to be used as a control VLAN. |
disable |
Disables the Ring Protocol functionality. |
forwarding-shift-time |
Sets the reception hold time for flush control frames. |
mac-clear-mode |
Set the target of MAC address table to be cleared by Ring Protocol function. |
mode |
Sets the operating mode for a ring. |
multi-fault-detection mode |
Sets the monitoring mode for multi-fault monitoring. |
multi-fault-detection vlan |
Sets the VLAN used as the multi-fault monitoring VLAN. |
name |
Sets the name for identifying a ring. |
vlan-group |
Sets the VLAN group for which to run the Ring Protocol functionality, and the VLAN mapping ID. |
The following tables list the operation commands for Ring Protocol.
Command name |
Description |
---|---|
show axrp |
Shows Ring Protocol information. |
restart axrp |
Restarts a Ring Protocol program. |
dump protocols axrp |
Outputs to a file detailed event trace information and control table information collected by the Ring Protocol program. |
show port #1 |
Shows the usage status of the Ring Protocol for a port. |
show vlan #2 |
Shows the usage status of the Ring Protocol for a VLAN. |
- #1
-
See "Operation Command Reference" and "20 Ethernet".
- #2
-
See "Operation Command Reference" and "23 VLAN".