20.4.1 Command list
The following table lists the commands used to configure Ethernet.
Command name |
Description |
---|---|
bandwidth |
Sets the bandwidth. |
description |
Sets supplementary information. |
duplex |
Sets duplex mode. |
flowcontrol |
Sets flow control. |
frame-error-notice |
Sets the condition for sending a notification when a frame reception error or a frame sending error occurs. |
interface gigabitethernet |
Specifies an Ethernet internet configuration with a maximum line speed of 1000 Mbit/s. |
interface tengigabitethernet |
Specifies the configuration of the Ethernet interface with the highest line speed 10Gbit/s. |
link debounce |
Sets the time required before a link-down is detected. |
link up-debounce |
Sets the time required before a link-up is detected. |
mdix auto |
Set the auto MDI/MDIX function. |
mtu |
Sets the Ethernet MTU. |
power inline |
Set the power supply priority for each port. |
power inline allocation |
Sets the per-port power allocation. |
power inline delay |
Set PoE power supply start wait time of the device and the power supply start interval of PoE port. |
power inline priority-control disable |
The port that is already powered is given priority. |
shutdown |
Shuts down Ethernet. |
speed |
Sets the speed. |
system flowcontrol off |
The example below shows how to disable flow control for all ports on the switch. |
system mtu |
Sets a value for an Ethernet MTU device. |
The following table lists the operation commands related to Ethernet.
Command name |
Description |
---|---|
show interfaces |
Displays Ethernet information. |
clear counters |
Clears the Ethernet statistics counters. |
show port |
Displays Ethernet information in list format. |
activate |
Changes the status of an Ethernet port from inactive to active. |
inactivate |
Changes the status of an Ethernet port from active to inactive. |
test interfaces |
Conducts a line test. |
no test interfaces |
Stops a line test, and displays the test results. |
show power inline |
Displays device and per-port PoE. |
activate power inline |
Restart the power supply manually. |
inactivate power inline |
Stops the power supply manually. |