17.2.1 Command list
The following table lists the commands used to configure the log output facility.
Command name |
Description |
---|---|
logging event-kind |
Sets the message type of the log data to be sent to syslog servers. |
logging facility |
Sets a facility to which log information is output via the syslog interface. |
logging host |
Sets the output destination for log information. |
logging syslog-dump |
Logs generated by the Switch are not stored in the on-chip flash memory. |
logging syslog-version |
Specifies the format version of syslog messages that are sent to syslog servers. |
logging trap |
Sets the level of importance for log information to be sent to the syslog server. |
Command name |
Description |
---|---|
logging email |
Sets the email address to which log information is output as an email. |
logging email-event-kind |
Use E-Mail to set the message type of the log information to be output. |
logging email-from |
Sets the sender of the log information output as an email. |
logging email-interval |
Sets the interval for sending output log information as an email. |
logging email-server |
Sets the SMTP server information for outputting log information as an email. |
The following table lists the operation commands related to the log output facility.
Command name |
Description |
---|---|
show logging |
Shows the log entries recorded by the Switch. |
clear logging |
Erases the log entries recorded by the Switch. |
show logging console |
Shows the contents set by the set logging console command. |
set logging console |
Controls the screen display of operation messages by event level. |