12.1.1 Command list
The following table lists the configuration commands used to set the switch operation mode, and the operation commands used to check the operation mode and status.
Command name |
Description |
---|---|
system fan mode |
Sets the operating mode of the fan. |
system l2-table mode |
Sets the search method for the Layer 2 hardware table. |
system recovery |
The no system recovery command specifies that no recovery processing is to be performed if a problem occurs, and the failed part will remain shut down. |
system temperature-warning-level |
An operation message is output when the temperature inside the device exceeds the specified temperature. |
switch provision |
Sets the model of a Switch. |
Command name |
Description |
---|---|
show version |
Displays information about the Switch software and the board installed. |
show system |
Shows the Switch's operating status. |
clear control-counter |
Resets to zero the number of the full and partial restarts due to a failure. |
show environment |
Shows the status of the chassis fan and power supply unit, the temperature, and the total operating hours. |
reload |
Restarts the switch. |
show tech-support |
Shows information about the status of the hardware and software required for technical support. |
Command name |
Description |
---|---|
show flash |
Shows internal memory usage. |
show mc |
Shows the memory card format and card usage. |
format mc |
Formats the memory card for use by the Switch. |
Command name |
Description |
---|---|
show cpu |
Shows CPU usage. |
show processes |
Shows information about processes being executed by the switch. |
show memory |
Shows information about the amount of memory being used by the switch. |
df |
Shows the available disk space. |
du |
Shows the amount of space being used by the files in a directory. |
erase dumpfile |
Erases the dump file. |
show dumpfile |
Lists the dump files stored in the dump file storage directory. |