7.2.1 Command list
The following table lists the commands used to configure the connection and remote operation of operation terminals.
Command name |
Description |
---|---|
ftp-server |
Permits access from remote operation terminals using FTP. |
line console |
Sets parameters for the RS232C port. |
line vty |
Allows remote access to the appliance. |
speed |
Sets the communication speed of the RS232C port. |
transport input |
Regulates access from a remote operation terminal using the various protocols. |
The following table lists the operation commands related to connection and remote operation of operation terminals.
Command name |
Description |
---|---|
set exec-timeout |
Specifies the length of time until the user is automatically logged out. |
set terminal help |
Selects the type of command help messages to be displayed. |
set terminal pager |
Enables or disables paging. |
show history |
Shows a log of operation commands executed in the past. (No log is displayed for configuration commands.) |
telnet |
Connects via Telnet to the remote operation terminal that has the specified IP address. |
ftp |
Transfers files between the Switch and a remote terminal connected by using TCP/IP. |
tftp |
Transfers files between the Switch and a remote terminal connected by using UDP. |
For information about configuring SSH, see 9 SSH(Secure Shell).
For configuration commands related to VLAN settings and IP interface settings, see "24 VLAN", "31 IPv4 communication", or "32 IPv6 communication".